Install Open Style Push Through Center Caps

By Method Race Wheels | Off-Road Wheels | Published: 2026-10-24

Category: How-to Guides

Step-by-step guide to installing open style push through center caps on manual locking hubs. Learn the correct size and push technique.

Quick answer

Install open style push through center caps by selecting the correct size for your manual locking hub, then pressing the cap into the wheel bore until it snaps into place.

Why choose an open style push through cap

Open style push through center caps are specifically designed for trucks with manual locking hubs, like older Ford F-250 and F-350 models. They allow you to maintain access to your manual hubs without removing the cap, making routine hub adjustments or servicing much more convenient.

Size matters: 62mm vs 110mm

Method offers these caps in two heights: 62mm (for 2005-present trucks) and 110mm (for 1998-2004 trucks). Choosing the wrong height can result in a poor fit or the cap not seating flush against the wheel. Always verify your vehicle's model year before purchasing.

Installation steps

Select the correct cap height: Measure your wheel bore depth or check your truck's model year. Use 62mm caps for 2005-present models and 110mm caps for 1998-2004 models. Using the wrong height can prevent the cap from seating properly or cause it to pop out.
Clean the wheel bore: Wipe away any dirt, grease, or debris from the inside of the wheel bore where the cap will sit. A clean surface ensures a secure fit. Debris can cause the cap to sit unevenly or not lock in place.
Align the cap with the bore: Hold the cap so the open side faces outward and the push-through tabs are aligned with the bore opening. The cap should slide in straight without forcing. If the cap feels tight, check alignment; do not hammer it in.
Push the cap into place: Apply even pressure with both hands (or a rubber mallet if needed) until you hear or feel the cap snap into the retaining groove. It should sit flush against the wheel face. A common mistake is pushing at an angle, which can bend the tabs. Ensure the cap is straight before applying force.
Verify secure fit: Give the cap a gentle tug to confirm it is locked in. If it moves or feels loose, remove it and check for obstructions or damage to the tabs. A loose cap can fall out while driving. Reinstall or replace if needed.

Product details

Center Cap | Open Style Push Through | Black: Open Style Push Through Center Cap for manual locking hubs. Available in 62mm (2005-present) and 110mm (1998-2004) tall options. This cap is purpose-built for older F-250/F-350 owners with manual hubs, letting you keep the Method look while still accessing the hub.
Center Cap | Open Style Push Through | Black