How to Install Center Caps on Method Wheels

By Method Race Wheels | Off-Road Wheels | Published: 2026-10-29

Category: How-to Guides

Learn how to install screw-on center caps on Method wheels, including tips for Sprinter van fitments. Step-by-step guide with common mistakes to avoid.

Quick answer

To install a screw-on center cap on your Method wheel, align the cap with the threaded hub, hand-tighten it clockwise, and then snug it with a wrench—do not overtighten.

Why screw-on caps differ from snap-in caps

Screw-on center caps, like the Center Cap | Sprinter | Screw-On | Chrome, use threads instead of spring clips. This makes them more secure for larger wheels but requires careful alignment to avoid cross-threading. The Sprinter van 17x7.5 fitment with 301 wheels is a common application.

Trade-off: Chrome finish requires care

The chrome finish on this center cap is durable but can scratch if tools slip. Use a rag over the wrench to protect the surface. Also, the cap is sold as a single unit, so order one per wheel.

Step-by-step installation

1. Prepare the wheel and cap: Clean the threaded area on the wheel hub with a dry cloth to remove dirt or grease. Unpack the center cap and verify that the installation hardware (screws, if included) is present. Dirt on threads can cause cross-threading or uneven seating.
2. Align the cap with the hub: Hold the cap so the embossed METHOD logo is oriented upright (or as you prefer). Gently place it over the hub threads, ensuring the cap's threads align with the wheel's threads. Do not force it. If the cap doesn't start easily, rotate it slightly counterclockwise until you feel the threads mesh.
3. Hand-tighten the cap: Turn the cap clockwise by hand until it is snug against the wheel. Stop when you feel resistance—this is the natural stopping point before using a tool. Overtightening by hand can strip threads; stop at snug.
4. Final snug with a wrench: Use a wrench (typically a 19mm or 21mm, depending on cap design) to give the cap a final quarter-turn. Do not use a power tool. If hardware screws are included, install them now through the cap's holes into the wheel. A quarter-turn past hand-tight is enough. Over-tightening can crack the cap or damage threads.
5. Check and repeat: After all caps are installed, give each one a visual check. Ensure the logo is straight and the cap sits flush. Repeat for remaining wheels. A crooked cap may indicate cross-threading—remove and re-align immediately.

Product facts

Center Cap | Sprinter | Screw-On | Chrome: Sold as single unit. Screw-on center cap with embossed METHOD logo. Replacement for Sprinter van 17x7.5 fitments with 301 wheels. Installation hardware included. You need one cap per wheel, and the included hardware means you don't have to source extra screws or washers.
Center Cap | Sprinter | Screw-On | Chrome