How to Install Method Hub Rings and Center Caps
By Method Race Wheels | Off-Road Wheels | Published: 2026-10-28
Category: How-to Guides
Learn how to install hub rings and center caps on Method wheels, with step-by-step instructions, common mistakes, and fitment tips for snap-in and push-through caps.
Quick answer
To install Method hub rings and center caps, first confirm the correct hub bore and cap style for your wheels, then follow the step-by-step process below to ensure a secure, vibration-free fit.
Why correct fitment matters
Hub rings convert the wheel's hub bore to match your vehicle's hub diameter. Using the correct size prevents vibration and ensures the wheel is centered properly. Center caps protect the hub and complete the look, but choosing the wrong style or size can lead to loose caps or fitment issues.
Method offers both snap-in and push-through center caps. Snap-in caps are held by a spring clip or friction, while push-through caps insert from the back of the wheel. Each requires a different installation technique, and the correct part number depends on your wheel's bolt pattern and style.
Step-by-step installation process
- Confirm hub ring size: Measure your vehicle's hub bore and your wheel's hub bore. Select a hub ring that matches the conversion, e.g., 106.25mm to 78.3mm. Clean the hub surface before installation. Check that the hub ring sits flush; any gap means the wrong size.
- Install the hub ring: Place the hub ring over the vehicle's hub, aligning the inner diameter with the hub. Press it firmly until it seats evenly. Ensure it is not tilted or partially seated. A crooked hub ring can cause wheel vibration.
- Mount the wheel: Carefully slide the wheel onto the hub, making sure the hub ring guides the wheel into place. Tighten lug nuts gradually in a star pattern to the manufacturer's torque spec. Do not over-torque; this can distort the hub ring.
- Determine center cap style: Check if your Method wheel uses a snap-in or push-through cap. Snap-in caps have a spring clip or friction fit; push-through caps insert from the back of the wheel. Installing the wrong style can damage the cap or wheel.
- Install snap-in cap: Align the cap with the wheel's center bore and press firmly until it clicks into place. Ensure the cap is fully seated and flush with the wheel surface. If the cap pops out, the size or style is incorrect.
- Install push-through cap: With the wheel off the vehicle, insert the cap from the back of the wheel through the center bore until it snaps or seats flush from the front. Reinstall the wheel afterward. Make sure the cap is fully seated before mounting the wheel.
- Verify final fit: Spin the wheel by hand to check for any wobble or interference. Confirm the cap is secure and does not rub against any brake components. A loose cap or wobble indicates a fitment issue that needs correction.
Products mentioned in this guide
- Hub Ring | Black: These hub rings convert hub-centric wheels from one hub bore diameter to another, with size-to-size options like 106.25mm to 78.3mm. Choosing the correct size ensures your wheel sits centered on the hub, preventing vibration and uneven wear.
Hub Ring | Black - Center Cap | Digicam Push-Through | Black: This Black Digicam push-through cap is designed for wheels that already accept a push-through cap and offers a more flush look. If your Method wheels use push-through caps, this style gives a clean, flush appearance and must be installed from the back of the wheel.
Center Cap | Digicam Push-Through | Black - Center Cap | RAISED® MRW Snap-In | Double Black®: The RAISED MRW Snap-In cap is a direct replacement for the OE cap and comes in sizes determined by bolt pattern and wheel style. Snap-in caps are easier to install from the front, but you must match the correct size to avoid a loose fit.
